Thursday , 27 February 2025

Binding Tactic Radio to Receiver

Binding Tactic Radio to Receiver

Instructions for binding a Tactic 2.4GHz transmitter to your receiver.

This procedure has been tested with the following:
Transmitters
• Tactic TTX240
• Tactic TTX300
• Tactic TTX404

Receivers
• Tactic TR324
• Tactic TR325

The Procedure
Step 1.
Turn on the transmitter.

Step 2.
Plug your car battery in and turn on the receiver.

Step 3.
– If the receiver LED flashes once and then stays on, the receiver is already bound to this transmitter; skip to step 4.
– If the receiver LED does not flash or stay on, insert a small diameter screwdriver through the hole marked “BIND” or “LINK” on the receiver. Press the push-button until the receiver LED glows red and then turns off after about one second.

Step 4.
Release the “BIND”/”LINK” button. If the binding is successful, the receiver LED will flash once and then remain on.

All set! If the transmitter doesn’t control the car, repeat steps 1-4 above.

Links
Tactic, www.tacticrc.com

About Tony Phalen

Tony Phalen - As an avid RC enthusiast, Tony has been building, bashing and racing RC Cars for over 30 years. He has participated in every kind of surface racing events - 1/18 scale trucks, 1/10 scale TC, Rock Racers, Rally - if it had wheels, he's raced it! He's also worked on both sides of the industry fence; collaborating with many major manufacturers (as well as being a sponsored driver) to working for a high-profile industry magazine. During this time he has learned many tricks, tips and techniques and is sharing that knowledge on CompetitionX - the most informative RC website on the internet!

Check Also

Team Associated RC10 2025 Metallic Edition Kit

Team Associated RC10 2025 Metallic Edition Kit

Team Associated has released yet ANOTHER version of the RC10, the 2025 Metallic Edition kit. …

9 comments

  1. I have a tactic TX/RX question on why when i plug a battery to the truck the receiver just blinks and I have no steering or throttle

  2. Can you bind a Tactic 2.4GHz Surface transmitter with an Air receiver, and visa-versa?

  3. My tactic x240 does not seem to have a bind button

  4. Hey George; the bind button is on the receiver, not the transmitter. Thanks for shooting me a message about this as well. I guess I should be a little more specific with the instructions.

  5. I suppose you could, but it would be a trial and error thing. Not all surface/air equipment likes to play together.

  6. My TTX240 and TR324 is not working anymore. The steering rudder is ok but not the throttle. I have a steady red LED on both. But endless beeping alarms.

  7. Usually this the case when the signal from the radio to the receiver is interrupted. I would try binding the system again and see if that fixes the problem.

  8. Will a tactic ttx300 bind with a 324 receiver? Can seem to get it to bind. My old ttx240 broke and I bought a 300 to connect to the 324 that was already installed in my UL1 boat

  9. Yes, it should work with the 324.