Monday , 23 December 2024

HPI Flux Shot 4300KV Brushless Motor

HPI Flux Shot 4300KV Brushless Motor
HPI Flux Shot 4300KV Brushless Motor

Add a shot of power to your car or truck with the Flux Shot Brushless Motor! Rated at 4300KV (equivalent to a 9-turn modified brushed motor), the Flux Shot is the perfect way to get into brushless power for any car or truck!

Combine with the #101749 Flux Reload v2 Brushless ESC for a major boost to any standard brushed motor RTR kit! This is the standard motor in the Bullet Flux truck, so you know it’s got loads of power!

Specifications:
9T/4300KV 540 sized Motor, diameter – 35.8mm
Length – 50mm (without shaft), shaft diameter – 3.17mm
Shaft length – 15mm, weight – 165g
Machined aluminum heatsink casing, ballraced

#101279 FLUX SHOT 4300KV BRUSHLESS MOTOR $152.00

[source: www.hpiracing.com]

About Tony Phalen

Tony Phalen - As an avid RC enthusiast, Tony has been building, bashing and racing RC Cars for over 30 years. He has participated in every kind of surface racing events - 1/18 scale trucks, 1/10 scale TC, Rock Racers, Rally - if it had wheels, he's raced it! He's also worked on both sides of the industry fence; collaborating with many major manufacturers (as well as being a sponsored driver) to working for a high-profile industry magazine. During this time he has learned many tricks, tips and techniques and is sharing that knowledge on CompetitionX - the most informative RC website on the internet!

Check Also

ProtoFORM PTzero1 Touring Car Body | CompetitionX

ProtoFORM PTzero1 Touring Car Body | CompetitionX

ProtoFORM is ending 2024 strong with this super-sleek PTzero1 Touring Car body set. It is …

2 comments

  1. Hey I purchased a Bullet Flux St and the fan in the ESC goes in and off if I touch the wires that lead to it. I returned it luckily got another one and the same thing. What could the problem be? Have you heard of this before?

  2. Sounds like the solder joint on the circuit board was loose. Did you contact HPI directly or your local hobby store? I would suggest contacting HPI directly…sounds like an issue in the assembly line of the ESC’s.