![Tamiya TA06 Pro Tamiya TA06 Pro](http://static.competitionx.com/uploads/2011/11/tamiya-ta06-pro-build-opener.jpg)
The Build – Part 5
Part 5 of the TA06 Pro build includes mounting the tires, front bumper, body mounts and the battery. Part 5 should be pretty straightforward and allow you the time for your tires to completely glue in place.
Build Notes:
Your front foam bumper may need to be trimmed depending on the body you are running. I would suggest making small cuts at first using an Xacto, then cleaning it up and smoothing it out with a Dremel or something similar.
The TA06 Pro will accept any type of 2S LiPo. Be careful so that when you install it you route the wires accordingly.
![Tamiya TA06 Pro Build Step 49 Tamiya TA06 Pro Build Step 49](http://static.competitionx.com/uploads/2011/11/ta06-build-49.jpg)
For racing rubber, I went with Tamiya’s B-Compound tires with their soft, molded blue insert. I kept and glued the tires to the stock multi-spoke wheels.
![Tamiya TA06 Pro Build Step 50 Tamiya TA06 Pro Build Step 50](http://static.competitionx.com/uploads/2011/11/ta06-build-50.jpg)
Careful gluing not only makes sure the tires bond well to the wheels, it also gives the overall tire a professional look. I use my CompetitionX Gloo Toobs to ensure a perfect bond and keep the mess to almost nothing.
![Tamiya TA06 Pro Build Step 51 Tamiya TA06 Pro Build Step 51](http://static.competitionx.com/uploads/2011/11/ta06-build-51.jpg)
When gluing, keep the tires on something you don’t care if it gets damaged. Thi helps prevent ‘glue rings’ from forming on your mom’s/girlfriends/wifes dinner table.
![Tamiya TA06 Pro Build Step 52 Tamiya TA06 Pro Build Step 52](http://static.competitionx.com/uploads/2011/11/ta06-build-52.jpg)
Give it a little time (which will vary depending on the glue used) and then flip over and repeat for the backside.
![Tamiya TA06 Pro Build Step 53 Tamiya TA06 Pro Build Step 53](http://static.competitionx.com/uploads/2011/11/ta06-build-53.jpg)
Install the rear body mounts per the instructions. Pretty simple.
![Tamiya TA06 Pro Build Step 54 Tamiya TA06 Pro Build Step 54](http://static.competitionx.com/uploads/2011/11/ta06-build-54.jpg)
Install the dogbone pins and wheel hexes on all four corners of the car. Feel free to use a little grease to hold the pin in place.
![Tamiya TA06 Pro Build Step 55 Tamiya TA06 Pro Build Step 55](http://static.competitionx.com/uploads/2011/11/ta06-build-55.jpg)
Install the front bumper and bumper top-plate per the Tamiya instructions. Nothing difficult here.
![Tamiya TA06 Pro Build Step 56 Tamiya TA06 Pro Build Step 56](http://static.competitionx.com/uploads/2011/11/ta06-build-56.jpg)
Drop the battery in the center of the chassis and secure the bottom panel with 4 screws. Be caferul which way you install the battery. Putting it in backwards will only mean disassembling the radio box again.