The Gears 10 is a new 1:8 Scale Nitro Buggy from AMR.
Feature
• Shaft-driven 4WD
• Smaller gear differential units
• Center limited slip clutch
• Adjustable front & rear down stop
• Adjustable rear toe angle & kick-up angle
• 8 degree approach angle
• 4 degree departure angle
• Long stroke suspension design
• 3 shoe type clutch
• Big bore shocks
• 58c.c. fuel tank / bubble filter inside
• Dirt-proof receiver & battery box
• Turnbuckle steering rod & suspension tie rod
• All Ball Bearing
• Wing mount adjustable angle
• Alum. Muffler & manifold included
• Front / rear universal swing shaft
• Can use the starter box in the market to start GEARS 10
Radio Sanwa Radio (AM)
Engine: 10CX Pull-Start Engine
Steering Servo: Sanwa standard servo
Throttle Servo: Mini-size coreless digital servo (metal gear)
Starter Set: 500cc fuel bottle, C-type battery glow plug igniter, plug wrench
Specification
Wheel Base: 240~243mm
Width: 250mm
Tire & wheel type: 1/10 EP Buggy type
Gear Ratio: 11.02:1 ~ 13.46:1
Weight: 1500g (RTR)
[source: www.amrtech.com.tw]
Were can i get a pullstart amr 10 nitro engine
IF you can find one, I would assume some place like eBay. I’m not sure if you can find any new ones anymore. Time for an upgrade! 🙂