Tamiya TRF419XR Touring Car Build – Part 6 – Anti-Roll Bars | CompetitionX

Step 1:

First thing – be aware that the bars are different sizes. The one on the top is for the front, the one on the bottom is for the rear.

Step 2:

Assemble the standoffs – these will connect the bars with the arms. Pay attention to the ballcups uses as well (there are several different ballcups included with the TRF419XR).

Step 3:

Assemble the bars. You don’t need to tighten down the rod stoppers just yet; we’ll do this in a later step.

Step 4:

Install the rear bar. Slide the bearing into the bulkheads followed by the rod stoppers. Cinch the 2.5mm setscrew down in the rod stopper until hits the bar. Do not overtighten.

Pop the standoffs onto the bar and connect it to the arm.

Step 5:

Same with the front.

Use the links below to follow each step.
Tekno ET410 Truggy Build – Opening Page
Tamiya TRF419XR Touring Car Build – Part 1 – Chassis/ Bulkheads
Tamiya TRF419XR Touring Car Build – Part 2 – Rear Differential
Tamiya TRF419XR Touring Car Build – Part 3 – Driveline
Tamiya TRF419XR Touring Car Build – Part 4 – Steering
Tamiya TRF419XR Touring Car Build – Part 5 – Suspension
Tamiya TRF419XR Touring Car Build – Part 6 – Anti-Roll Bars
Tamiya TRF419XR Touring Car Build – Part 7 – Shocks
Tamiya TRF419XR Touring Car Build – Part 8 – Final Assembly