The Build – Part 12 Here we go, the final step. We are only showing the tires mainly because the body is a pretty simple step and requires painting (which we can’t help you with). …
Read More »Tag Archives: team associated
Team Associated RC8.2 Build – Part 11 – Engine and Fuel Tank
The Build – Part 11 Installing the engine and fuel tank are pretty easy. We will also be covering the assembly of the clutch to the engine which can be a little more detailed. Your …
Read More »Team Associated RC8.2 Build – Part 10 – Linkage
The Build – Part 10 The throttle linkage can be a bit tricky on nitro powered vehicles. Once set, however, you should not have to adjust it again. The RC8.2 also features an adjustable brake …
Read More »Team Associated RC8.2 Build – Part 9 – Radio Tray
The Build – Part 9 The radio tray is the heart of your RC8.2. This tray is connected to the chassis with 6 screws. Removing these 6 screws will allow you to quickly remove the …
Read More »Team Associated RC8.2 Build – Part 8 – Shocks
The Build – Part 8 The Factory Team RC8.2 comes with a killer set of threaded shocks. They build easily and require very little maintenance unless, of course, you prefer to rebuild after every race …
Read More »Team Associated RC8.2 Build – Part 7 – Center Differential
The Build – Part 7 The center differential assembly is a pretty straightforward step. Since we already built the center diff, it’s must a matter of assembling the mount and attaching it to the chassis. …
Read More »Team Associated RC8.2 Build – Part 6 – Rear Suspension
The Build – Part 6 The rear suspension is a little time consuming but not hard at all. Take your time, don’t forget your loctite and grease and you’ll be good to go. Build Notes: …
Read More »Team Associated RC8.2 Build – Part 5 – Rear Bulkhead
The Build – Part 5 The rear bulkhead builds much like the front one. This should be a quick and easy step. Build Notes: There are few areas where you will be screwing into aluminum …
Read More »Team Associated RC8.2 Build – Part 4 – Front Suspension
The Build – Part 4 The front suspension is pretty simple. You will want to make sure that all the moving parts move freely and aren’t bound up. Build Notes: This step will require quite …
Read More »Team Associated RC8.2 Build – Part 3 – Front Bulkhead
The Build – Part 3 The front gearbox is a pretty easy build. It will require you to attach the front shock tower, install the differential and build the center drive axle. Build Notes: There …
Read More »